How To Use Ohmic In A Sentence
-
Bilayers of Ni / Au and Al / Ti were deposited by e-beam evaporation as p- and n-type ohmic contacts for current injection.
-
Given differing loads with ohmic, inductive or capacitive external resistance gives rise to the dependence of output voltage on load current as shown in Figure 135.
8. Transformer
-
We believe this activation is probably an ohmic phenomenon like an instantaneous I-V relation.
-
At low potentials, pores remain open and demonstrate ohmic behavior.
-
In high external potassium the current did reverse at the expected potassium equilibrium potential but it did not follow the expected ohmic relations.
-
It can be concluded that the ohmic potential drop is an important factor which has the influence over the pit growth kinetics.
-
But as the temperature of heated plasma rises, the resistance decreases and the ohmic heating becomes less effective.
Nuclear fusion power
-
This is called ohmic (or resistive) heating; it is the same kind of heating that occurs in an electric light bulb or in an electric heater.
Nuclear fusion power
-
There is no prominent change of gelatinization properties during ohmic heating.
-
As far as the dangers go, its a lot safer than nuclear fission power (the reactor types that are being used now) because it produces virtually no radiation or nuclear waste (ohmic heating of a plasma in a tokamak replaces the irradiated water if a fission reactor which produces nuclear waste).
Think Progress » FACT CHECK: Combating Global Warming Does Not Require ‘Economic Castration’
-
The reason for this starts with surface inhomogeneities that lead to nucleation of the deposition process in one spot, after which ohmic and transport effects lead to further amplification of this inhomogeneity.
Archive 2010-09-01
-
If the voltmeter contacts are non-ohmic, they may rectify any AC pickup present and cause a DC offset error.
-
If the current source contacts are non-ohmic, there may be a significant difference in the compliance voltage when the source polarity is reversed.
-
Fluorescent lamps can also be operated by direct current voltage, if the lacking a.c. resistance is replaced by an ohmic resistance and the lamp is pole-changed from time to time with the help of an intermediate switch.
5. Light Sources for Illuminating Purposes
-
The exposed backside is recessed at the central gate location to define the current path which connects the source and drain ohmic contacts.
-
In order to improve the quality of control, an ohmic base load has to be connected to the load exit of the device according to the instructions of the manufacturer (e.g. filament lamps 25 W).
6. Operating Components for Discharge Lamps
-
The windings in the operating field yield an ohmic resistor, the internal resistor R1.
6. Direct current machines
-
A relation between an increase in the ohmic resistance and the ohmic restriction resistance of a conducting plate with a sharply changing width is shown.
-
It appears that the maximum plasma temperature attainable by ohmic heating in a tokamak is 20-30 million degrees Celsius.
Nuclear fusion power