How To Use Microfarad In A Sentence
-
A one-half microfarad condenser is placed in the receiver circuit at each station so that the line will not be tied up should some subscriber inadvertently leave his receiver off its hook.
Cyclopedia of Telephony & Telegraphy Vol. 1 A General Reference Work on Telephony, etc. etc.
-
The original determination of the microfarad, brought out under the auspices of the British Association Committee on Electrical
Memoir of Fleeming Jenkin
-
If a telephonic set at T1 (Fig. 2) communicate through the line to a distant station, T2, through a condenser, C, of a capacity of half a microfarad, conversation is still perfectly audible, provided the telephonic system is one that acts by induction currents.
Scientific American Supplement, No. 443, June 28, 1884
-
The power amp section contains a large, very heavy, power transformer and uses 15,000 microfarad capacitors which give the SX-880 about 2db of dynamic headroom.
More of Mephistopheles - novel gans title, loses some cohesion and some other stuff like Utah Saints
-
For interference suppressing (elimination of radio interference), suppressor capacitors of 0.022 microfarad/250 C are connected in parallel per lamp at the lamp feeding point (illuminator entrance).
5. Light Sources for Illuminating Purposes
-
The condensers ordinarily used in telephone practice range in capacity from about 1/4 microfarad to 2 microfarads.
Cyclopedia of Telephony & Telegraphy Vol. 1 A General Reference Work on Telephony, etc. etc.
-
The original determination of the microfarad, brought out under the auspices of the British Association Committee on Electrical Standards, is due to experimental work by Jenkin, described in a paper, 'Experiments on Capacity,' constituting No.IV. of the appendix to the Report presented by the Committee to the Dundee Meeting of 1867.
Memoir of Fleeming Jenkin
-
Paper capacitors usually range in value from about 300 picofarads to about 4 microfarads.
-
If desired, that value can now be converted to microfarads by moving the decimal point six places to the left.
-
Mr. A.P. Trotter said Mr. Ferranti informed him that the capacity of his mains was about 1/3 microfarad per mile, thus making
Scientific American Supplement, No. 795, March 28, 1891
-
His third prototype culminated his design, which, he wrote, is ‘a simple switching gate circuit which produces an AC current; the cycle rate is achieved by the use of two one megohm resistors and a 0.01 microfarad capacitor.’
-
It made use of two condensers of 1 microfarad each, one in each side of the cord circuit.
Cyclopedia of Telephony & Telegraphy Vol. 1 A General Reference Work on Telephony, etc. etc.
-
Start capacitors have much higher ranges and can be purchased in sizes all the way up to 800 microfarads.
-
Using equal capacitance of 12 to 16 microfarads per horsepower should result in a satisfactory balance.
-
Capacitance values range between 47 microfarads and 1,500 microfarads with ESR as low as 6 milliohms.
-
M. Bouty mentions a condenser of one microfarad capacity weighing 1500 grms. and contained in a square box measuring 12 centimetres on the side, and about 3 centimetres thick.
On Laboratory Arts
