How To Use Garboard In A Sentence
-
I wonder if this is just the garboards or if the developments for the other plank are also incorrect.
-
After the new garboards are installed, we'll tighten or refasten all the copper nails.
-
Here is a series of pictures of the process of gluing and screwing the garboard planks.
-
Assessment of her condition was completed when the garboards were removed to make all visible.
-
The elm used for the garboard was for greater rot resistance and the fact that elm is very tough wood.
-
We could say our boat's pulled up in the ravine cove for repair of a sprung garboard strake.
IRONCROWN MOON: PART TWO OF THE BOREAL MOON TALE
-
Traditionally, wooden boats had a bronze threaded plug in their garboard for just this reason.
-
However, it is normal practice to caulk the garboard strake and the hood ends with cotton caulking, or oakum in heavier work, and seal it over with a filling compound.
-
Planks were usually screwed at the ends and, in some cases, the garboard strakes received similar treatment.
-
When dry, the completed garboard was removed from the building frame and the scarphed joins sanded smooth.
-
This tongue forms a very solid backing for the garboard strakes and is pierced with holes in pairs as shown from side to side.
-
The assembly of the garboards with the middle body of the keel is made by mortise-and-tenon joints.
-
After the garboards and inside keel are fiberglassed, the hull is ready for sanding, painting, and finish woodwork.
-
I have never had to employ oak garboards, but I would do it without hesitation should the need arise.
-
Didn't trust her any more, hadn't for the last two years since he had found rot in the garboard strakes.
CORMORANT
-
We expect that removal of the garboards and other planks will force replacement of at least some backbone components.
-
The dark mahogany color of the garboards make for quite a contrast with the birch planks above.
-
Sailboats are some times fitted with a garboard drain plug to serve the same function when wintering ashore.
-
This operation, if accurately performed, will give the exact shape of the lower edge of the garboard.
-
Her garboard strake is three inches thick; her planking two and one-half inches thick; her deck - planking two inches thick and in all her planking there are no butts.
Chapter 2
-
The second garboard was cut out using a router and a pattern-cutting bit using the first garboard as a pattern.
-
They replaced the keelson and garboards, learning on the job; they sanded 18 layers of paint off the deck.
-
The rest of the hull is glassed with one layer and the bottom and garboards are further coated in epoxy and graphite.